NXP (founded by Philips) LPC1114/203

The NXP (founded by Philips) LPC1114/203 is a System - ARM Cortex-M0 processor, running at frequencies of up to 50 MHz. - ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC). - Non-Maskable Interrupt (NMI) input selectable from several input sources - Serial Wire Debug. - System tick timer. Memory - Up to 64 kB on-chip flash programming memory. - Up to 8 kB SRAM. - In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software. Digital peripherals: - Up to 42 General Purpose I/O (GPIO) pins with configurable pull-up/pull-down resistors. - GPIO pins can be used as edge and level sensitive interrupt sources. - High-current output driver (20 mA) on one pin. - Four general purpose counter/timers with up to eight capture inputs and up to 13 match outputs. Analog peripherals: - 10-bit ADC with input multiplexing among 5, 6, or 8 pins depending on package size. Serial interfaces: - UART with fractional baud rate generation, internal FIFO, and RS-485 support. - Two SPI controllers with SSP features - I2C-bus interface Clock generation - 12 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used as a system clock. - Crystal oscillator with an operating range of 1 MHz to 25 MHz. - Programmable watchdog oscillator with a frequency range of 7.8 kHz to 1.8 MHz. - PLL allows CPU operation up to the maximum CPU rate without the need for a high-frequency crystal. May be run from the system oscillator or the internal RC oscillator. - Clock output function with divider that can reflect the system oscillator clock, IRC clock, CPU clock, and the Watchdog clock. Power control: - Integrated PMU (Power Management Unit) - Power profiles residing in boot ROM - Three reduced power modes: Sleep, Deep-sleep, and Deep power-down. - Processor wake-up from Deep-sleep mode via a dedicated start logic using up to 13 of the functional pins. - Power-On Reset (POR). - Brownout detect with four separate thresholds for.