Spansion MB9AF132K

The Spansion MB9AF132K is a 32-bit ARM Cortex-M3 Core (r2p1) - Up to 20MHz Frequency Operation - Nested Vectored Interrupt Controller (NVIC) - 24-bit System timer (SysTick) On-chip Memories - Up to 128 Kbyte Flash - 8 Kbyte SRAM Multi-function Serial Interface (Max. 8channels) - UART, CSIO, LIN, I2C A/D Converter (Max. 16channels) - 12-bit A/D Converter - Priority conversion available (priority at 2levels) Base Timer (Max. 8channels) - Operation mode: 16-bit PWM, 16-bit PPG, 16/32-bit reload, 16/32-bit PWC General Purpose I/O Port - Up to 52 fast general purpose I/O Ports - Some pins are 5V tolerant I/O Multi-function Timer - 16-bit free-run timer x 3ch. - Input capture x 4ch. - Output compare x 6ch. - A/D activating compare x 3ch. - Waveform generator x 3ch. - 16-bit PPG timer x 3ch. Real-time clock (RTC) External Interrupt Controller Unit - Up to 8 external interrupt input pins - Include one non-maskable interrupt (NMI) input pin Watchdog Timer (2channels) Clock and Reset - 5 clock sources (2 ext. osc, 2 built-in CR osc, and Main PLL) - Reset sources: INITX Pins, POR, SW, Watchdog, LVD, CSV Clock Super Visor (CSV) - Ext. OSC clock failure (clock stop) detect - Ext. OSC frequency anomaly detect Low Voltage Detector (LVD) - LVD1: error reporting via interrupt - LVD2: auto-reset operation Low-Power Consumption Mode - 3 power saving modes (SLEEP, TIMER, STOP) Low-Power Consumption Mode - 6 low-power consumption modes (SLEEP, TIMER, RTC, STOP, Deep standby RTC, Deep standby STOP) Back up register is 16bytes. Debug - Serial Wire JTAG Debug Port (SWJ-DP).