Spansion MB9AFB44N

The Spansion MB9AFB44N is a 32-bit ARM Cortex-M3 Core (r2p1) - Up to 40 MHz Frequency Operation - Integrated Nested Vectored Interrupt Controller (NVIC) - 24-bit System timer (Sys Tick) On-chip Memories - Up to 256 Kbytes Main Flash - 32 Kbytes Work Flash - SRAM0: Up to 16 Kbytes (connected to I-code bus or D-code bus) - SRAM1: Up to 16 Kbytes (connected to System bus) External Bus Interface (not MB9AFB41LA/FB42LA/FB44LA) - Supports SRAM, NOR Flash memory device - Up to 8 chip selects - 8/16-bit Data width - Up to 25-bit Address bit USB Interface - USB function USB2.0 Full-Speed supported Max 6 EndPoint supported - USB host USB2.0 Full/Low-speed supported Max 256-byte packet-length supported LCD Controller (LCDC) Multi-function Serial Interface (Max 8chn) - UART, CSIO, I2C DMA Controller (8chn) A/D Converter (Max 24chn) - 12-bit A/D Converter Base Timer (Max 8chn) -Operation mode: 16-bit PWM, 16-bit PPG, 16/32-bit reload, 6/32-bit PWC General-Purpose I/O Port - Up to 83 high-speed general-purpose I/O Dual Timer (32/16-bit Down Counter) HDMI-CEC / Remote Control Receiver (Max 2chn) Real-time clock (RTC) Watch Counter External Interrupt Controller Unit - Up to 16 external interrupt input pins - Include non-maskable interrupt (NMI) input pin Watchdog Timer (2chn) CRC (Cyclic Redundancy Check) Accelerator Clock and Reset - 5 clock sources (2 ext. osc, 2 CR osc, and PLL) - 6 Reset sources (INITX pin, POR, SW, Watchdog, LVD, CSV) Clock Super Visor (CSV) Low-Voltage Detector (LVD) - LVD1: error reporting via interrupt - LVD2: auto-reset operation Low-Power Consumption Mode - 6 low-power consumption modes SLEEP, TIMER, RTC, STOP, Deep standby RTC, Deep standby STOP Debug - Serial Wire JTAG Debug Port (SWJ-DP) - Embedded Trace Macrocells (ETM): MB9AFB41LA/MA, FB42LA/MA, FB44LA/MA only SWJ-DP.