NXP (founded by Philips) LPC1518

The NXP (founded by Philips) LPC1518 is an ARM Cortex-M3 processor - running at frequencies of up to 72 MHz - Nested Vectored Interrupt Controller (NVIC) - System tick timer. - Serial Wire Debug (SWD) Memory: - Up to 256 kB on-chip flash (ISP and IAP) - Up to 36 kB SRAM - 4 kB EEPROM Digital peripherals: - Simple DMA engine with 18 chn - up to 76 General-Purpose I/O (GPIO) pins - GPIO interrupt generation capability - 2 GPIO grouped port interrupts - Switch matrix for flexible configuration of each I/O pin function - CRC engine - Quadrature Encoder Interface (QEI) Timers - 2 State Configurable Timers (SCT) in large config. - 2 State Configurable Timers (SCT) in small config. - SCT Input Pre-processor Unit (SCTIPU) - 24-bit, 4-channel, multi-rate timer (MRT) - Repetitive interrupt timer - Windowed Watchdog timer (WWDT) - High-resolution 32-bit Real-time clock (RTC) Analog peripherals: - 2 12-bit ADC with up to 12 input chn per ADC - 1 12-bit DAC - Integrated temperature sensor - 4 comparators Serial interfaces: - 3 USART interfaces - 2 SPI controllers - 1 I2C-bus interface - 1 C_CAN controller - 1 USB 2.0 FS device controller with on-chip PHY Clock generation: - 12 MHz internal RC osc. - Crystal osc. (operating range of 1 MHz to 25 MHz) - Programmable watchdog osc. - 32 kHz low-power RTC osc. - System PLL allows CPU operation up to the maximum CPU rate - 2 additional PLLs for generating the USB and SCT clocks - Clock output function with divider that can reflect various clocks Power control: - Integrated PMU (Power Management Unit) - Reduced power modes: Sleep, Deep-sleep, Power-down, Deep power-down - APIs provided for optimizing power consumption - Wake-up from Deep-sleep and Power-down modes on activity on USB, USART, SPI, I2C - Timer-controlled self wake-up from Deep power-down - Power-On Reset (POR) - BrownOut Detect BOD) Unique device serial number for identification.