Peripheral Simulation

For Infineon C164SI — Timer Block GPT1 (T2, T3, T4)

Simulation support for this peripheral or feature is comprised of:

• Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

Timer/Counter 2 Dialog

The Timer/Counter 2 dialog allows you to view and change the SFRs associated with Timer/Counter 2. This timer/counter is a general purpose unit which may be used for timing, counting, and so on.

• Mode contains the operating mode and the input selector for the timer.
• T2UDE is the external up/down control enable.
• T2EUD is the external up/down control input. This value is obtained from the T2EUD input pin.
• T2UD is the timer up/down control.
• Direction displays whether the timer/counter counts up or down.
• Status displays the current status of the timer.
• T2 contains the value of the T2 SFR which is the current timer value or count.
• T2CON contains the value of the T2CON SFR which is the current configuration for timer 2.
• T2R is the Timer 2 Run flag.
• T2IN is the Timer 2 Input value.
• T2IR is the Timer 2 Interrupt Request flag.

Timer/Counter 3 Dialog

The Timer/Counter 3 dialog allows you to view and change the SFRs associated with Timer/Counter 3. This timer/counter is a general purpose unit which may be used for timing, counting, and so on.

• Mode contains the operating mode and the input selector for the timer.
• T3UDE is the external up/down control enable.
• T3EUD is the external up/down control input. This value is obtained from the T3EUD input pin.
• T3UD is the timer up/down control.
• Direction displays whether the timer/counter counts up or down.
• T3OTL is the output toggle latch flag.
• Status displays the current status of the timer.
• T3 contains the value of the T3 SFR which is the current timer value or count.
• T3CON contains the value of the T3CON SFR which is the current configuration for timer 3.
• T3R is the Timer 3 Run flag.
• T3IN is the Timer 3 Input value.
• T3IR is the Timer 3 Interrupt Request flag.

Timer/Counter 4 Dialog

The Timer/Counter 4 dialog allows you to view and change the SFRs associated with Timer/Counter 4. This timer/counter is a general purpose unit which may be used for timing, counting, and so on.

• Mode contains the operating mode and the input selector for the timer.
• T4UDE is the external up/down control enable.
• T4EUD is the external up/down control input. This value is obtained from the T4EUD input pin.
• T4UD is the timer up/down control.
• Direction displays whether the timer/counter counts up or down.
• Status displays the current status of the timer.
• T4 contains the value of the T4 SFR which is the current timer value or count.
• T4CON contains the value of the T4CON SFR which is the current configuration for timer 4.
• T4R is the Timer 4 Run flag.
• T4IN is the Timer 4 Input value.
• T4IR is the Timer 4 Interrupt Request flag.