Peripheral Simulation

For Infineon XC161CJ-16F — Reset Configuration

Simulation support for this peripheral or feature is comprised of:

• Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

Simulator Setup Dialog

The Simulator Setup dialog allows you to specify the reset configuration for the simulated MCU. This dialog available under Options for Target - Debug Tab - Simulator - Settings Button. At reset, the states of certain chip pins are used to configure the operation of the MCU. You may specify the following settings.

• SMOD represents the Special Modes specified in the RSTCFG register.
• BUSTYP represents the Bus Mode specified in the RSTCFG register.
• CLKCFG is the Clock Generation Mode Configuration in the RSTCFG register..
• SALSEL is the Segment Address Line Select in the RSTCFG register..
• CSSEL is the Chip Select Line Select in the RSTCFG register..
• WRC is the Write Configuration bit in the RSTCFG register.
• ADP is the Adapt Mode bit in the RSTCFG register.
• ROC is the RSTOUT Control bit in the RSTCFG register.
• EA# specifies the state of the /EA pin at reset.
• ALE specifies the state of the ALE pin at reset.
• RD# specifies the state of the /RD pin at reset.
• WR# specifies the state of the /WR pin at reset.