Peripheral Simulation

For NXP (founded by Philips) P89LPC952 — Timer 1 (Standard Timer + Pin Toggle + PWM Mode)

Simulation support for this peripheral or feature is comprised of:

• Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

Timer/Counter 1 Dialog

The Keil Debugger simulates all aspects of Timer/Counter 1. The configuration is reflected in the Timer/Counter 1 Dialog that you may open from the Peripherals Menu. You may use the controls in the dialog to override the settings configured by your target program. This allows you to learn how the timer/counter works by interactively changing the configuration settings.

Mode

• Mode settings select the size and auto-reload functions, and set either Timer or Counter operation.
• TCON (Timer Control Register) holds the run/stop and overflow flag for Timers 0 and 1.
• TMOD (Timer Mode Register) holds the mode, gate control and counter/timer select bits.
• TH1 (Timer 1 - High Byte) contains the upper 8-bits of the Timer 1 value.
• TL1 (Timer 1 - Low Byte) contains the lower 8-bits of the Timer 1 value.
• T1 Pin (Timer 1 Input Pin) reflects the state of the T1 input pin.
• TF1 (Timer 1 Overflow Flag) is set when when Timer 1 overflows.

Control

• Status (Timer/Counter Status) displays the current status of the Timer/Counter.
• TR1 (Timer 1 Run Control) is set to turn Timer 1 on, and reset to turn it off.
• GATE (Gating Control) is set to enable a timer/counter while the INT1 flag is high and run control (TR1) is set.