Peripheral Simulation

For ABOV Semiconductor MC96F6408A — Port 2

Simulation support for this peripheral or feature is comprised of:

• Dialog boxes which display and allow you to change peripheral configuration.
• VTREGs (Virtual Target Registers) which support I/O with the peripheral.

These simulation capabilities are described below.

Parallel Port 2 Dialog

This dialog displays the SFR and state of Port 2. The I/O pins of Port 2 may be configured to operate as input or output ports.

• P2 represents the P2 SFR value. The HEX value and value of each bit is displayed and may be changed from this dialog.
• Out represents the current state of the P2 pins configured for output.
• In represents the states of the pins on the simulated MCU. When used as outputs, these have the same value as the P2 SFR. When used as inputs you may set the level of the input pin to high (1) or low (0).

You may use the PORT2 VTREG to change the state of the input pins on the simulator command line or in user or signal functions.

PORTx VTREG
Data Type: unsigned char

The PORTx VTREGs represent the I/O pins of the simulated MCU for Port 0, Port 1, and so on. PORT0 represents Port 0, PORT1 represents Port 1, etc. You may read PORTx to determine the state of the output pins of that port. For example, in the command window, you may type,

PORT0

to obtain value corresponding to the set pins of Port 0. You may also change the input values of port pins by changing the value of the VTREG. For example,

PORT1=0xF0

sets the upper four port pins of Port 1 to a value of 1 and the lower 4 port pins to a value of 0. You may use the bitwise operators AND(&), OR(|) and XOR(^) to change individual bits of the PORTx VTREGs. For example:

PORT1 |=  0x01;  /* Set P1.0 Pin */
PORT3 &= ~0x02;  /* Clr P3.1 Pin */
PORT1 ^=  0x80;  /* Toggle P1.7 Pin */