Texas Instruments Low-Power RF (formerly Chipcon) Debug Driver

This Texas Instruments Low-Power RF (formerly Chipcon) driver allows you to debug your application with uVision via the on-chip two-wire debug interface. The two-wire debug interface is supported by TI's SmartRF04EB development kit

This driver supports the following devices:

• CC1110
• CC1111
• CC2430
• CC2431
• CC2510
• CC2511

This new driver version now also supports the CC Debugger which provides a USB interface to the PC.

The CC1010 is supported by a different driver, which can be downloaded from Texas Instruments' web page.

Please download the file below and install this driver as described in the readme file. When you configure debugging, the Chipcon SmartRF04 Driver will be available and it will connect to your target system once you start a debug session.