SWPACK: RCC component not available with STM32F7 DFP 2.11.0

Information in this knowledgebase article applies to:

• Keil MDK 5
• STM32F7::DFP 2.11.0

SYMPTOM

I am using the Device Family Pack Keil::STM32F7xx_DFP 2.11.0 and I want to configure Reset and Clock Control parameters (RCC). But the RCC component of the STM32Cube HAL is missing.

I see an error reported by the Manage Run-Time Environment:

Component is not available for target...

CAUSE

Version 2.11.0 of the Keil::STM32F7xx_DFP unfortunately does not cover the RCC component.

RESOLUTION

1. Upgrade: Download the Keil::STM32F7xx_DFP 2.12.0 Device Family Pack or later, using the Pack Installer.
2. Revert: Select the Keil::STM32F7xx_DFP 2.10.0 version of the pack using the Select Software Packs.
3. Overwrite the File: use the attached file to replace replace Keil.STM32F7xxDFP.pdsc_ at the corresponding folder %InstallDir%\ARM\PACK\Keil\STM32F7xxDFP\2.11.0 (_after saving the original file).

MORE INFORMATION

• Refer to Configure System & Clock
• Refer to Managing Run-Time Environment in the µVision User's Guide.

SEE ALSO

• ARM: STM32F7: hard fault caused by unaligned Memory Access
• SWPACK: STM32F7xx: Processor Halt
• Application Note 280 µVision Lab for the STM32F746G-Discovery Board

ATTACHED FILES

Request the files attached to this knowledgebase article.

Last Reviewed: Monday, October 19, 2020