Keil MCB2140

The Keil MCB2140 Evaluation Board works with the ULINKpro USB-JTAG Adapter. The following instructions show you how to connect and run an example program on this board.

ULINKpro Adapter Connected to MCB2140

To download and run an example project using ULINKpro with the Keil MCB2140 Board:

1. Connect the 20-pin ribbon connector from the ULINKpro Adapter to the JTAG port of the MCB2140 evaluation board.
2. Make sure that Jumper J9 - JTAG is ON.
3. Connect power to the board using a standard USB cable.  Connect the other end of the USB cable to an unused USB connector on your PC. 
4. Start µVision.
5. Select the BLINKY.UV2 example project from C:\KEIL\ARM\BOARDS\KEIL\MCB2130\BLINKY\.
6. Click the Download button to download the program to the target board.
7. Click the Debug button to start the debugger.
8. Click the Run button to start the program running on the target board.